ESP M1

ESP M1

Combined Type 1, 2 and 3 tested protector (to BS EN 61643) for use on mains power distribution systems primarily to protect connected electronic equipment from transient overvoltages on the mains supply, e.g. computer, communications or control equipment. For use at boundaries up to LPZ 0 to protect against flashover (typically the main distribution board location, with multiple metallic services entering) through to LPZ 3 to protect sensitive electronic equipment.

• ESP415M1R includes remote display with LED status indicator.

Installation Install in parallel, within the power distribution board or directly (via fuses) on to the supply feeding equipment. At distribution boards, the protector can be installed either on the load side of the incoming isolator, or on the closest outgoing way to the incoming supply. Connect, with very short connecting leads, to phase(s), neutral and earth. For TT installations, contact Furse.

Temperature Range: -40°C to + 80°C
Connection Type: Screw Clamp
Conductor Size (stranded): 35mm²
Volt Free Contact: Connect via screw terminal with conductor up to 2.5mm² (stranded)
Protection: IP20
See Downloads Tab for full Datasheet, Fitting Instructions and DofC

Swipe table
ESP240M1 5414363086321 1+2+3 7 240V Single 60mm 180mm 73mm WBX3 £317.00 £380.40
ESP415M1 5414363086352 1+2+3 7 240V Three 60mm 180mm 73mm WBX4 £633.00 £759.60
ESP415M1R 5414363086369 1+2+3 7 240V Three 60mm 180mm 73mm WBX4 £706.00 £847.20

To help improve our website we use cookies, by using this site you agree that we may store these on your device. For more information on what cookies are and why we use them please read our Cookies and Privacy Policy.